ETCHELLS SPEEDY TIPS
Quick Tips That Make All The Difference
Whether you are preparing for the Worlds, a local regatta, your country’s nationals or your club’s summer series, we have compiled a series of speedy tips from North Sails Etchells experts that will help you step up your results.
Don’t forget the jib trim setup. We spend a lot of our time focusing on the mainsail when the headsail is usually 67% of the total drive force.
Light Air Jib Setup Under 8 knots
- Use the soft full length batten.
- Add forestay sag by easing the backstay.
- Add prebend in the mast by easing the mast lever or reducing mast blocks.
- Trim the sheet to have the upper leech tell tale flying 90 to 100% of the time.
Jib Trim
Use the tuning guide’s spreader marks as your trim guide for consistency.
Battens For Light Air
Use the soft full length top batten combined with the shorter length lower leech battens. They make a big difference.
Getting A Good Start Is Critical
The more you can practice starting, the better. Work on your line sights before each start and work to get a “movie” line sight for the bow person, watching to leeward as you approach the line so they can be calling accurate distance to the line as you approach. That, plus a good clear call on time is invaluable.
Straight Starting
The Etchells is a heavy keelboat with the rudder attached to the skeg and does not turn that well. Try not to bear off too much on starboard in the last 45 seconds to the start. Keep the jib trimmed in, or luffing about halfway if necessary, to help the helmsperson find the right angle to build speed in the last 15 seconds or so.
Watch The Layline
Unless you are in the top 3-5 boats at the first windward mark, NEVER EVER get to the layline more than 10 lengths from the mark because you’ll spend too much time in bad air from the boats ahead. Instead, find a clear lane back to the middle, and then work to get up to the layline inside ten lengths from the mark. Bad things happen to good people who get to the layline too early!
Do Your Homework
Arrive a few days before each event to get reacquainted with the boat and your teamwork. A day or so of practice really helps shake the cobwebs, and, if you are working with a coach, is a chance for some good analysis of setup and general trim. Having a good training partner helps a bunch, especially if both teams are keen to learn and share.
Never Stop Practicing Time/Distance Drills for Starting
Good starts typically yield good finishes. In the uber-competitive Etchells fleet, getting off the line is essential as the fleet thins out very fast and lanes are at a premium. Try to get proper line sights (safe ones!) and practice accelerating and decelerating as you approach the line. The goals are always the same: cross the starting line as close as you can, on your best exit angle, and at top speed!
Don’t Wait Too Long To Take Down The Spinnaker
The Etchells will keep its momentum into the bottom mark and any loss you think you give up with an early drop is overshadowed by a clean rounding in a good lane with speed and everyone hiking. Speaking of hiking, it works every time, so don’t take long breaks in the breeze. The Etchells responds nicely to a hard hiking crew, even though it hurts!
Tuning Evolution
It is amazing to see how this great boat continues to evolve. The addition of the mast lever and intricate in-haul systems have really helped make the boat so much more adjustable from the rail. You can adjust your sailing mode to the racing situation: maybe a high mode to live in a lane, or a more open bow-down mode to capitalize on a shift. I have been sailing these boats since the 1980s and I am still learning every time I race them.
Smooth Versus Bumpy Water Set Up
I have found that fast settings for smooth water often do not work as well in bumpy water and vice versa. Bumpy water versus a big sea swell also changes what set up works best. In general terms, fuller sails with more twist seem to work well when the water is rough, while flatter sails with harder sheeted leeches seem to be better when the water is flat.
Spreader Angle and its Effect on Mainsail Luff Curve
Each Etchells mast is a little different in bending characteristics. The mast ram can have a big effect on getting the mast to match the sail’s luff curve, but spreader angle also has a part to play here. A more forward or straight-out spreader angle makes the mast stiffer. A more aft-sweep spreader angle lets the mast bend more easily, particularly in the middle section. A fair curve that matches the sail best is the ticket.
In Miami, Consistency Pays
Miami continues to be venue where consistency pays. Taking chances usually produces a high scoring race. I try to be conservative on the line, starting in the middle third. From there, I work my way to the favored side as I progress up the first leg.
New Sails are Better Than Old Sails!
We used unbuttoned sails for the first 3 winter series events to save our buttoned sails for the Midwinters, a sanctioned event. Fresh sails do make a difference, especially with jibs.
Flat Water Tuning
Biscayne Bay is very specific with its flat water conditions. Most other venues tend to have more chop or swell, so you’ll have to revert back to settings with a little less rake and slight fuller flying shapes.
Find A Clear Lane
Find a clear lane free from boats too close to leeward, so you can put the bow down and reach max speed.
Put The Keel To Work
It often takes as long as a minute to reach max speed with the bow down. After you do, you start to sail higher as the keel begins to work.
Crowded Leeward Mark
At the leeward mark, if you are in a group of boats with only a marginal chance of gaining an inside overlap, hold back and round behind to allow a high lane exit. This allows you to sail to the side for longer. Tacking back into the middle too soon after rounding is usually a loser.