NORTH SAILS BLOG
All
Events
Guides
News
People
Podcast
Sustainability
Tech & Innovation
Travel & Adventure
FLYING FIFTEEN TUNING GUIDE
FLYING FIFTEEN TUNING GUIDE FR-3/FR-5 MAINSAIL & NXG-3 JIB
WIND SPEED (knots)
0 - 4
5 - 8
9 - 12
13 - 16
17 - 22+
Sea State
Flat <---> Choppy
Flat <---> Choppy
All Sea States
All Sea States
All Sea States
Mast Rake
24'11 (7595mm)
24'10 (7570mm)
24'10 (7570mm)
24'9 (7545mm)
24'8 (7520mm)
Rig Tension
180 kg <---> 160 kg
160 kg <---> 140 kg
160 kg
160 kg
180 kg
Kicker Tension
Slack (set for downwind)
Just snug
Tension until 2nd tell tail on the leech stalls 10% of the time
Increase tension bit by bit as the wind increases
30-50%
Ram
Pull fwd 30mm <---> Pull fwd 20mm
Pull fwd 15mm <---> Pull fwd 10mm
Neutral position
Neutral position
Ease fwd 5mm
Outhaul
Ease 10mm from max <---> Ease 20mm from max
Ease 20mm from max
Ease 10mm from max
Max outhaul
Max outhaul
Cunningham
None (see notes)
None (see notes)
None (see notes)
Removing all wrinkles on the luff
Increasing to max tension
Jib Inhauling
None (see notes)
50% <---> 25%
25-50%
None
None
Jib Luff Tension
Soft, slight wrinkles on luff
Soft, slight wrinkles on luff
Just removing wrinkles
No wrinkles
Firm
Notes:
Spreader Length:
420mm-430mm based on overall crew weight, heavy teams should use 430mm, lighter teams 420mm, (if under 23stone then reduce to 410mm)
Spreader Angle:
FR-3 mainsail use 175mm, for FR-5 mainsail use 185mm
Ram:
The Neutral position is set on the dock using 24'10 rake and 350lbs of rig tension, this should produce around 20-25mm of pre bend, Mark this position at deck, this is the zero point or Neutral. Move the ram from this position the amount in the guide.
Cunningham:
Our mainsails use a rubber luff rope which is slightly elasticated which helps to release tension when the cunningham is eased, it does mean it can create larger wrinkles off the luff so its best to lightly snug the cunningham in the lighter winds to remove the larger of these wrinkles without affecting sail shape.
Jib Inhauling:
With the newer higher aspect jibs there is the option to sheet the sail closer to the centreline, there are too many different sheeting setups to give a measurement figure but if you try using the max you think you could inhaul for a short spell, 30 seconds off a start line for example, this is 100% inhaul, use the % guide figure as a ball park to how much you can use in regular sailing in the longer term. I.e 8 kts in flat water would be the likely most effective inhauling condition using 50% of max. You need to ensure the boom is on or even slightly over the centreline to make this work as effectively as possible.
READ MORE
READ MORE